124 models
Write a label and slide it into the slits of this pot stake.
A pentagonal succulent planter, about 7 x 7 x 4 inches: a last-minute Mother's Day gift.
A tapered twist shade with a built-in M40 x 2.5 thread for common lamp sockets.
A screw-mount holder for up to four toothbrushes.
A snowflake-shaped spinner for seven 22 x 7 mm skate bearings.
A four-level 3D tic-tac-toe that almost never ends in a draw.
A tic-tac-toe board with a pull-out drawer that stores the pieces.
Extra pieces that work with common 24 mm marble-run sets: curves, funnels and splitters.
A cute curled-up sleeping dinosaur figurine.
Dice with fractions (1/2, 1/3, 1/4, 2/3, 3/4, 3/2) made for math teachers' games.
A tiny desk holder for four SD cards.
A tray that holds 87 standard 1/4-inch hex screwdriver bits.
A sturdy 8-inch bracket for 10 to 12 inch shelves. Print with 4+ walls.
Holds two adult toothbrushes, a kids' toothbrush and two toothpaste tubes with big caps.
A clamp-on rod holder for a boat rail, tightened with a 1/4-inch stainless bolt.
Holds four fishing rods on a garage ceiling or wall.
An ultralight tent peg designed for carbon-fiber filament: about 6 g each at 140 mm.
A two-piece dipper that holds an egg in the dye cup. Fits large and jumbo eggs.
Show off logo golf balls from courses you've played, on the wall or a desk. OpenSCAD source included.
A stand for necklaces, bracelets and rings on a dresser or at a craft-fair booth.
Two stick figures holding up your books, printed without supports.
Hexagonal mini planters that clip together on any side or stack into a living wall.
A small screw-on or stick-on clip for thin cables up to about 4.5 mm.
One side holds a phone or tablet at 45° for videos, flip it for 70° in portrait. Tiny, quick print.